Between Omaha and Des Moines, 7 miles South of I80 | I'm going to question: Why two 10 foot gates and not just one 20 foot steel pasture gate? {note: I assume these will be swinging gates = hanging} Do you plan to create an overlap, on those two 10 foot gates, in the "center" ; so they can be chained together(with a little overlap, like 1.0-1.5 FT) and don't bang around, in the wind? 2nd note: If you do raise your cross brace, try to "plan ahead" on where your horizontal barb wires will be and center your cross brace, between them = that gives you a little more room, to wrap the "ends of your wire", on your corner posts, after you cut them to the appropriate lenght. Internet photo, of cross brace, in the center (of top wires):
Edited by 4WD 12/8/2018 15:14
 (0416pc-falbo-h-brace (full).jpg)
Attachments
----------------
 0416pc-falbo-h-brace (full).jpg (220KB - 46 downloads)
|
Building those braces
