AgTalk Home
AgTalk Home
Search Forums | Classifieds (138) | Skins | Language
You are logged in as a guest. ( logon | register )

Case IH 5400 drill good, bad, and ugly?
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
Sharecropper jr.
Posted 11/20/2018 08:58 (#7116979 - in reply to #7116758)
Subject: RE: Case IH 5400 drill good, bad, and ugly?


Deep southern Illinois		I can’t comprehend how you’d have a clutch problem with a solid stand Great Plains? On ours the drive wheel lifts off the ground when you pick the drill up. Other than being small a solid stand 1500 is a pretty good drill. Sometimes had some problems with rubber seed tubes kinking when trying to run the Coulter’s too shallow in worked ground. If you’re breaking row units off, you’re turning way too sharp. Also, you can make the row units walk down the frame, and not follow the Coulter’s causing it to drag up. And don’t forget to lock the center pivot going down the road. It’ll get wild quick.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)