Big Sky Country | lukean - 8/21/2018 18:58
3.25 Cessna/Eaton Wireloc rephrasing cylinders. Just rebuilt one on a 960 Deere Cultivator a few weeks back. Was around $113.00 for the kit with new wires included. You don't pull the wires out, you turn them out. Have taken them to hydraulic houses before but last time it was around $300.00 for the rebuild, done them myself ever since. Very common on Deere stuff from the 70s thru 90s.
they like making them outa tubes and using wire as it's a cheap way to go---plus you can make a weird length so off the shelf stuff is wrong length.
grapple cyl on my loader were that way---I redid the brackets , bought some fittings and replaced both with off the shelf--closed 'bite' is right now, standard replacement will work, whole deal cost less than one new morhidite from J.D. Plus went a bit slimmer, cycles faster now. |
John Deere Hyd. Cylinder Rebuild Kit
