|
| I got all the med. black spools that hydraulic hose came on for the people that made them up . A light tubing that fits thru it hooked on wires of my pickup box stake holes. holes thru end of tubing to pin in place. Then had a 4" sewer plug I chucked in Dewalt cordless and held it against one of the outside big edges and could roll alot of poly wire on one. Rolled all good wire on a few, rolled sorta good old wire on another and bad or junk wire on another.
When you roll it out you just tie it fast and drive forward with your arm out the window as a backlash prevention/brake. Two people can put up wire as fast as you can walk, (the guy putting in step in plastics) Guy in truck leaves off 20-25 posts every now and then.Guy walking is pacing off spacing,,, stepping in,,, and snapping in wire.
2 can roll out and post a mile in an hour, takes a bit longer if your only installer
Get to the corner and you pull tight and tie off to your corner insulator tied with a length to a solid fence post or drive one steel post leaning out of the corner
Picking them up you wind wire and drive along and pull posts thru the window. Pretty quick when you get on it or 2nd guy on tailgate,driver watching thru mirror.
Edited by don@nebr 8/21/2018 19:36
| |
|
Homemade wire winder ideas
