|
south texas | Not being rude but u are incorrect. The stc system is a top stop injector but with stc. Its in the older books. The oil lines going to the injectors is a dead give away plus ive had the injectors done twice with cummins literature coming back. The 6inlb is done at 0 load, ibc.
the 125inlb is in the book for the 855nta and n14 mechanical for obc.
STC Injector Adjustment (Outer Base Circle Method): Torque to 14 N•m [125 in-lb].
Use a dial-type torque wrench to tighten the injector rocker lever adjusting screw to the specified torque. If the screw causes chattering during setting, repair the screw and lever as required.
Hold the torque wrench in a position that allows the direct view of the dial. This is to make certain that the reading on the dial is accurate.
Torque Value: 14 n•m [ 125 in-lb ]
Edited by coastalBend 6/22/2018 22:07
| |
|
8970 855 cummins overhead set
