|
sw corner ia. | I have not heard of top stop injectors that were set to more than six (yes, 6) inch pounds. if I was going to run them down to 125 I would have to know for sure this is correct.
I also did not know you cold substitute ibc for obc method. yes, the motor they sold to deere for ag use is for sure different than automotive.
edit again: I wonder if the ag use motor just runs at a higher temperature throughout the motor since it is going to run at a constant load that they want a little more cold valve clearance?
Edited by dvswia 6/22/2018 14:16
| |
|
8970 855 cummins overhead set
