|
north central Ohio | Put a Cone Gaurd liner in much easier and a little cheaper no pulling of rotor. Straighten/weld rasp bar that should not cause a vibration as is though. Pull gear box off feeder house drive and rock trap off and check shafts over for wear while putting in a liner. If good grease well and put back together. Make sure to get lastest feeder house drive shaft if it needs replaced they are greasable. We also drilled and tapped and made our rock trap greasable too when it needed replaced. Thermostat we had quite a deal with finally determined seal was binding on sleeve of thermostat causing it to bind. Third time apart matched a seal out of a mid size case tractor rear axle seal to put in it and so far so good. So check seal over good. They look good but move the sleeve up and it will bind and not allow it to close. The electrical stuff might check over all the electrical connections you can find. Pull apart make sure they are dry and oring seal is in them to keep moisture out. Had issues with some on ours that caused some problems. Good luck! | |
|
Case IH 8120 combine problems
