|
Big Sky Country | john deere would sell you a cover for filter cover on transmission for a 4020 that had a port to dump oil back in.
I had shaver for yrs on industrial 3010. 25 gpm pump. it would start starving pump after maybe 15 full strokes. J.D. mech said no harm to overfill trans, that worked good.
Use 4055 now. It don't starve for oil, probably smaller pump and bigger 'reservoir'
On both, I use a bell reducer to dump return oil in where you fill it, one inch i.d. hose. Tried returning thru quick couplers and you lose tremendous amount of whack. Had driver on 3 pt, so return quite short.
On the 3010, there was a plugged extra port on hi pressure 'manifold'---I took supply right there---driver is HD10 and was very quick cycling.
I'd never mount 3 pt again. Always twisted around with foot on clutch, feel every lick and think big tires take some whack away.
I see 4wd posted while I was yakking on phone. lotsa info on old thread. good point on make sure you got closed center valve on driver.
Edited by littlejo 6/11/2018 12:38
| |
|
Shaver post driver return line on JD 6140D
