AgTalk Home
AgTalk Home
Search Forums | Classifieds (48) | Skins | Language
You are logged in as a guest. ( logon | register )

Can you enlarge a hole with a mag drill?
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
Hay Hud Ohio
Posted 6/8/2018 11:25 (#6800826 - in reply to #6800642)
Subject: mag drill tips



SW Ohio
If you want to use the mag drill and there is nothing flat to stick it to, weld a plate where you need it and remove it later. Also the thicker the plate the better the magnet sticks, i.e. 1/8" might let go but 1/2" holds tight. And if drilling not flat---sideways-upside down-etc use the chain, it will fall sooner or later.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)