|
WCIL | We just replaced a tire on our 1770. It was a little tough. We lubed it good with wd40 and got the steel half in then used 4 long bolts to draw the plastic half in, which also keeps the holes in line. Threaded rod would be best but we did not have any small enough, so we used bolts and washers and kept repeating until we got it. I would weld a nut or double nut one end to use an impact on, then use a wrench on the other. We also pried a little to relieve the tire a bit. A little time consuming but got it.
| |
|
What’s the easiest/best way to press a Deere gauge wheel back together?
