| kylewcill - 2/2/2015 02:23
I have a 12 farmall 95. We got it new dec 12. It has caused us a tremendous amount of trouble. The turbo went bad lights did not all work when we got it. Mechanical Shuttle shift grinds into gear it has been adjusted replaced at least 6 times. Radio works most of the time it didn't for quite a while. The 3pt arms don't want to go up or down. It had total electrical failure. Clutch went out at 600 hrs. The bolts that attach the drawbar to the tractor have came out. Its had 2 sets of rear wheel seals. The ac leaked when new. Its on its 3rd injection pump. Valve cover bolts came loose. The bolts that attach the loader brackets to the frame have broke numerous times and are just about a daily battle to keep tight. Now they are stripped. Friday night they gave it up and the loader on the left side pretty much fell off. Windshield wiper quit when new. It has had 6 or 7 sets of joystick cables cause they freeze up whenever cold. Tractor sits inside all the time during the winter and 95 percent of the time during the summer. Its had the throttle cable replaced it broke. Whenever its cold the quarter inch inline fuel filter gels. sure there is more. I have been fortunate to have a good dealership and service department to do the warranty work. My warranty ran out in december so I bought the extended warranty because I did not want to spend the money trading and was afraid to own tractor without. Now with the loader falling off I am looking at trading for a 95c. I cannot afford to spend a lot of money. Will I have the same trouble. 90 percent of the time we use this tractor to move and feed bales. I'm dead set against trading because I really do like this tractor it is the perfect size for our operation. We really hoped a plain jane tractor wouldn't have these issues. Is there anything or anyone at cnh to talk to about these problems. In 2 yrs 2 months it has spent 3 months at dealer getting fixed. I feel bad for the dealer cause they have been outgoing and they didn't build the tractor. Any thoughts ideas would be much appreciated. Thank you.
Do you know how the dealer fixed the 3pt arms not going up/down? I have a Farmall 95A and it has the same exact problem. The 3pt arms are working when you start the tractor, but after a few hours of working, they just stop responding, even if you hadn't used them at all. We have tried all sorts of repairs but nothing seems to work so far. |