|
N Central IA | I have a JD original display and mobile processor that I want to use in a JD 9220 GS ready tractor. I would like to use my S-2 for gps signal, and have the harness from Out Back to connect the two. I hooked it up according to Out Back directions and can't seem to get gps signal on greenstar display, I keep getting 110 code on display. According to Out Back I need to pull wires from pin C black wire and pin F white wire from GS display harness and replace with their red and black wires. I have S-2 set according to their instructions GGA 1Hz, RMC 1Hz,GSA 1Hz, and I have tried Baud at 4800 and 9600. Are these the right settings and the right wires for gps input into GS? I want to use GS display to enter my variety when I plant so when I combine the varieties are already entered, will this work if I have GPS signal from my Out Back? | |
|