|
| I posted earlier regarding difficulty achieving square bales on a consistent basis and we have yet to resolve that problem. I think the sensors are bad but Krone refuses to actually spend any money and continually suggests that I or my operators are the problem. However, when I put the same operator on a Massey baler, I don't have complaints from stacker operators. I have a good deal more knitter problems, I have bent 4 gauge wheel arms and then it dropped in a pivot track and caused damage in an amount close to 1/2 what the resale value apparently is. I know that neither I nor my help is perfect, but this thing is eating me alive and I don't know if I got a lemon or if they are just an optimal condition baler. My email i [email protected] if you'd care to get in contact. I don't care to detail much more here as I don't have enough experience to be fair
Edited by mtquick 9/6/2017 23:06
| |
|
Calling all Krone fans
