Posted 8/16/2017 09:52 (#6190275 - in reply to #6190216) Subject: RE: Kinze 3600 twinline, problems getting it to run level
Mid-Missouri
When, I replaced the wing hinge pins, I simply went to a machine shop and had them cut the shaft to the correct length. I also didn't drill holes in it to hold in from sliding out or rotating. I did bolt a tab to an existing bolt on the front and back of frame to prevent the pin from coming out IIRC. And like I said, I drilled and installed more grease zerks on the planter frame where there wasn't any.