210 Industrial Dr., Arlington Wisconsin 53911 | Deere at one time made half shafts - pto knuckle on head side and the chain coupler on the combine
side. They should be available used and maybe from Lankoda.The pto adapter as mentioned will work too.
Your combine probably has dial-a-matic with the 3 position switch in the combine. If the head has the triangle
shaped box on the right side and the right connector to plug into the combine it will work. If it has the
bell crank style switches on the right side ( active header height) then you need the kit from headsight or
at one time there was a kit to switch back to dial-a-matic. It consisted of the dial-a-matic box, harness, the
small divider, and the underside plate just behind it. I have switched several over the years when Headsight
company didn't exist. Many later 925's had contour master set ups on the head for combines
that had feeder houses that tilted so that set up may be on the head. If it is you will see a bell crank style
switch on the left side. Last many newer heads have single point hook up on the back of the head. you would
need to convert this if it has that on it.
Edited by jd7810 6/3/2017 21:25
|
925F header hookup.
