|
NE ND | I have found this is the only way to prime mine:
Put in new tube and screw tube holder on half way. With the plunger handle still out, I press the bleed button at the top of the gun. Hold that open and push the plunger handle in. Let go of the button once the handle is all the way in. Last, tighten the tube holder. Had a heck of a time the first couple tubes. Now it primes up in just a couple shots.
If half way through the tube you get air, just do like you did loading it. First pull the handle back until it hits resistance (don't try to pull it back all the way, this will only suck more air it). Next loosen the tube holder. Then hold the bleed button in and push the handle in. Let go of the bleed button and tighten the tube holder. | |
|
Milwaukee grease guns
