|
| This is ,The motor, that was smoking while idling
still a lot of smoke ,fuel not dripping ,out of the flex, on the exhaust while cold 25 deg out
Thing starts at 15 degrees in 10 seconds ,so I think we have good rings
when the 10Kohm resistor is in the plug for the heat sensor
I have a reading of 3.5 volts on one, and 0 on the other wire
had by mistake, bought a 10 ohm and I get 0 on both wires
this is with the motor running
with the plug empty I have 4.5 volts one, on 0 on the other
should I not have like 2 or 3 volts ,on the low side, for the ECM to read ?
TIA
Edited by hillfarmer 3/17/2017 13:10
| |
|