|
| Sure theoretically one could leak more than the other but that's why you use new and of the same type and run lower pressures. Your setup still is going to have issues unless your going to have full controlled drives. You can only use one encoder and so what if your pwms responds differently? You would need a drive with its own brain that can translate the pwm signal from the screen and then figure out how each motor should turn using 2 encoders. Leakage on a good brand name ( not Chinese) motor are very minimal and is not an issue.
Edited by fourcubs 3/17/2017 07:57
| |
|
Need help plumbing two hyd motors and one pwm valve?
