|
| Depending on hours, I would find out if the HI-Lo has been rebuilt. If it hasn't, find out if they normally run it in Hi or Lo. Hi is a direct throughput through a clutch pack, and lo is a planetary reduction. We have seen a lot of issues with high HP loads and running the 2 speed in Lo position. If the 2 speed hasn't been rebuilt ever, then figure in a possible 10-12,000 issue down the road. Other than that, the machines are solid.
Be sure to put the diagnostic fuse in, flip the turn signal until it says "All" on the corner post, pull the turn signal back to you, and write down any numbers that some up along with the letters. You won't believe how many dealership salesmen will not have the shop check them over and clear the codes, so you might find a problem right there. | |
|
JD 9300 reliablity?
