Shaftsbury, Vermont (SW VT) | Biggest wiring problems I've dealt with concern the wiring harness under the starter on the right side. Not too much room there to begin with, and if the motor mounts get soft, or the bolts fall out (can you say vibration?), the harness rubs through. Fix we have used is to run the repaired harness over top of the mount and up along the engine. Protect it from chafing while you're at it. Had an awful time doing that on a low profile 6200L. Everything is lower on that dash!
Vibration on the four cylinder tractors seems to eat up the mufflers, too. I don't know of a fix for that, but I think someone on here had one a while back. Oliver Durand |
6400 JD MFWA Good/ bad/ Ugly?
