|
Chillicothe, Missouri | Know a guy that does what you are talking about, he uses standard Hyd. quick couplers on the hoses. males on the engins, and females on the hoses. he would hook them yp, and put the pickup on fast idle, and then grease and check over the machine. once he was finished checking all the fluids the engine would be warm to the touch, and he would start it. when he disconected the lines it would dribble a little like hyd systems. once the lines were bled-out there wouldn't be any ari lock problem. I am not sure how far it would push the water, but it should have plenty of power esp. if the output is comming directly off the water pump. | |
|
? below re coolant flow and air lock.....prompts a ? about use of fluid transfer hoses............
