Thanks Guys ! When I put it on and it all worked, I thought I had it made, since I had planned to spend a morning on getting it setup. I know lowering the hitch too far aggravates the problem. I did move the pin on the mower side 1 hole, thinking less slack would be a help. I have been mowing ditches, which does not help any either. I understand the metal tab above the pulley, I already started cutting some metal for that, but thought I'd ask you guys for some help first. The drawbar is not the original,and it does sit higher than OE. Thanks for letting me know, that this can take some trial and error. As for the $38 pin, hmmm,that's the most you can get for $4.00 part! Smile! Thanks again! I'll sleep on it,and decide what I should do. I don't like the anchor eye sticking up where it can hit the pto shaft. Previous owner had it on a 756, but had not used it in 7 years. So far only I have run it, I want to get the bugs out before I turn others loose with it. |