|
| Raven replaced the original ones with the external lever. These valves have the flow limiter screws opposite each other. Still they are not the correct valves for the long PWM box. The thing that made the most difference was min and max drive in the service menu. Slow everything down until the spreader "hangs" to one side of the line, then speed things up. Trial and error on this. Opening the flow limiters all the way causes problems, but you can increase them a little. The best fix is the correct valve, but I am too tight to spend $1000+ each if I don't have to. | |
|
Hooking up an ITC receiver to a Smart trax system
