|
roaming | There might be a way to send the GPS signal over the ISOBUS wiring, but it would not be making use of the ISOBUS protocol. I believe you will find that the Deere tractor CAN bus is running a proprietary JD messaging system, which the Pro600 cannot understand. So a Pro600 plugged into a JD CAN bus won't do you any good unless there is ISOBUS messaging involved.
Also, just because the Pro600 and the 2600 both use the 26-pin Amp connector, doesn't mean they're wired the same. You could potentially damage the Pro600 by plugging it into the Deere harness, just as you could potentially damage a 2600 by plugging it into a CNH harness. | |
|
ISO compliant monitors & tractors JD & CIH
