|
Nebraska | Mine does this too on crappy days or when its super cold. Unplug the scale leads going into the scale head. I assume you have 5 pin weigh bars and 4 weigh bars total? Sometimes them pins loose contact and cause an "err" message, take some electrical contact cleaner and spray in them, then plug them back into the scale head. Make sure none of them little pins are bent, you can take a little screwdriver and tweak em a little if you have too.
Also just to mention make sure you are getting enough voltage to the system. If you weren't though it would tell you low bat so you are probably good there. | |
|
Feed wagon scale trouble
