Posted 1/6/2016 19:22 (#5016627 - in reply to #5016361) Subject: RE: Steiger CM 360, Cat 3406 died
Ok. If that is the case then they should be good.
If i did a complete major on it on this 310 motor I could turn it into a 360 hp by getting all parts passed on my 360hp motor parts. Except getting the right rods and bearings to match the crank that in the 310 motor.
I not sure if that makes sense to you or not.
I have tried finding a Ag motor but have had very little luck. So this is my alternative I guess.
I have seen pistons like that before so I know the timing is important. I Just didn't know there where so many different versions of this motor or specs i guess i should say.
Thank you for the good info.
Helps answer a lot of my questions. I will be heading to CAT next week to price a lot of this out.
If there is any other ideas you might have I would love to hear them
Steiger CM 360, Cat 3406 died
