South Africa | clausenm - 11/15/2015 01:26
Helping a friend connect an fmx to an AG ready 550 quad. Trimbles 67120 cable goes to the top of the cab but is female deutsch dtm, and the cab has female deutsch dt. You are supposed to have cnh 84258905 to connect the two, but only 4 wires are needed on the other end (75741 to the fmx) so it pains me to spend $135 when I could just make a dt to dtm short harness with 4 wires or just cut the end off of the 67120 and put a 12 pin dt connector on the end.
Long story short, trying to figure out of the 4 wires that head off of a 75741 cable to the 67120 cable (which I already have), where do they end up at the tractor cab connector?
Hope that makes sense!
Mathew
Just connect the same pin no's on the trimble harness to the same pin no's on the roof plug. Don't have it with me now, but they use exactly the same pin no's on both plugs. Should be Rx-2 and tx-3 gnd-5 if i remember correctly, but if you connect P2 to P2 exct. it will work. |
Caseih 84258905 pinout
