|
SW OH | I have put on 3 in the same day. No need to take out cylinder, just take off hose. On the bottom pulley stick a pry bar inside the spokes of the outer pulley and pry it apart. We used a wood splitting wedge in the spokes opposite the pry bar to hold it open. After you have it open, then take the brace plate loose from the bearing flange. Pull it out and slip new belt in. Use a small ratchet strap to hold pulley up while brace is unhooked. I have done it in less than 15 minutes in the middle of the field.
Mitchco | |
|