|
Fairview, MT | the cutterbar will be wavy, that is how the flex head flexes.
are you breaking guards in the same spot? or anywhere on the head?
one thing to check would be the fore/aft tilt of your feeder house. if this is incorrect, it could be putting a major pitch on the cutterbar.
how you adjust this is, raise or lower the feeder house until the pivot bolt for the fore/aft frame is 34 inches from the ground. then use the turnbuckles to make the front face of the feeder house perpendicular to the ground | |
|
New JD 630 head-beaking too many guards!!!
