AgTalk Home
AgTalk Home
Search Forums | Classifieds (29) | Skins | Language
You are logged in as a guest. ( logon | register )

Case ih 3020 grain head won't cut
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
redblooded
Posted 9/18/2015 21:23 (#4796477 - in reply to #4796447)
Subject: RE: Case ih 3020 grain head won't cut


Shelburne Ontario Canada
U did the dealer setup? Ours there was a rubber block bushing the header float torqued thru . On back side of head there are bout 5 threaded rod things wich u adjust with a 15/16 wrench . Have one guy on front by knife . With head raised up at waist hi the knife should have (i think it was 2-3" ) travel down against the stop .(from where it is push down with hand and let it bounce back up, then push down again and measure how far u push down against stop) If this is set wrong header puts to much force down on ground an shoves dirt
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)