|
| What I've always believed in is putting thicker blades on the front IF you can stand to change them all at once. If I were you I'd try real hard to hold out until I could.
In OUR conditions .256 blades up front and 7 ga (.187?) in the rear gangs would wear at relatively the same rate. When the fronts were in need of changing, the backs were also. I have never heard of anybody who had ANY LUCK AT ALL getting a disc to level correctly with new blades on one end and old on the other. Didn't seem to matter what brand or model of disc. Seems to be a universal thing. | |
|
Advice on replacing disk blades ( front or rear )
