|
SE IOWA | I went to high school at Lone Tree- graduated this year. But you can be in FFA till you are 21 so I think I'll continue taking projects to the state fair for a few years.
Some of the pieces are cut with a hi definition torch- I wanted them laser cut but the guy from Liebovich steel in cedar rapids said there would be no difference- he was right. I wish I could do this good with my plasma cutter! I wanted the cuts to look good since it was a State fair project. The torch was mounted on a computer controlled robot arm.
I didn't modify the boot much- I added some steel in the inside to help stuffing the start of a roll down the tube, planning on adding a press wheel inside and some fins on the outside to scuff up the sidewalls a little bit.
I got the plans from Agtalk member 17821x - they are .pdf files and files that laser cutter systems can read. | |
|