|
| I have a 11 Shank Case IH 6650/Glencoe SS7400 and pulled it in Minnesota clay hills with an John Deere 8640 (275 hp) that had all it wanted with 4" twisted points at 10" deep. Had to run B-1 or A-3 to pull on the hills, 3.5-5.5 mph. For the first five years it lived as a 9 shank behind a Massy 1805 (200 hp).
We used it 3 years behind our John Deere 8960 (370 hp) and now bought a John Deere 510 5 shank.
Disc chisels have there place and where I am is not one of them.
Edited by Snowdiesels91 5/12/2015 12:52
 (100_0401.JPG)
 (100_0519.jpg)
Attachments
----------------
 100_0401.JPG (129KB - 816 downloads)
100_0519.jpg (171KB - 815 downloads)
| |
|
Disc chisel hp requirements
