|
Spring Lake, MI | Given the NAT concern over Arc-blast, you may consider not keeping the dryer electric panel where you will undoubtedly spend a lot of time.
I can see a dryer control panel, or the typical 200A load center... But I wouldn't want the 3-pgase 600A disconnect anywhere but outside on a seperate post.
Our setup has the disconnect away from the common areas, the control oanel on the dryer (for safety at startip, etc,) a 100A load center inside a 12'x16' shed. Counter on one side for moisture tester, etc. bench on opposite side.
Goid luck | |
|