|
West central missouri | In December I purchased an 04 Challenger MT535B with 6000 hours. The 3-point did not respond to the cab controls. Tech support recommended replacing the position sensor on the right side of the rockshaft. We did that and it worked one time. But when it came back up (using the fender controls) the flange the sensor rides on went too far and allowed the sensor tip to go past the flange and when we went back down it bent the sensor to the tune of $327. Service tech came out, pulled the rockshaft cover , recovered the sensor tip and re-assembled. Installed new sensor. Identified the problem, but is stumped as to how to fix it. Any suggestions? | |
|
3-point problems Challenger MT535B
