|
Effingham, IL | Several years ago my oil pressure gauge was messing up. After replacing the sending unit and that wasn't it. I took the dash apart. If I remember right the studs on the gauges that go through eyelets in a circuit board were not making a good connection. I just wiggled and retightened the nuts on the guage studs. It's a pain to get to, but might be worth a try.
Edit: My operators manual doesn't have a wiring diagram. You will probably need some type of repair book! Craig
Edited by CW IL 8/25/2008 10:02
| |
|
4440 gauge ???
