golfnut - 2/18/2015 22:37 I broke down today and bought a new hot water pressure washer. Its a Shark/Karcher 3.5gpm/2000psi electric unit with a diesel burner. I'm anxious to use it but need to figure out exactly where I want to install it and then I need to vent it to the outside. Does anybody have pictures of how they vented theirs and along with any suggestions? Twp has a new one installed and the instructions give the necessary vent pipe size and such. Otherwise, pretty straight forward. Pipe up through the roof. Ours has power damper, to close to conserve heat and such. It's also a 12 inch pipe - but ours is 400,000 but unit (5gpm @ 1500 psi). Go online and you should be able to find the directions on needed venting. | 
Pressure Washer Venting
