|
| I finally had some luck getting information from Trimble via my CASEIH deaker through their Precision Farming guru.
He told me the on the FM-750, Port A and Port B are identical. The pioout to export a DGPS signal from the 750 is as below.
Pin 3 -- TX
Pin 4 -- RX
Pin 5 -- Ground
I am having a cable made with this info to connect to a Raven Smart Boom controller at the Smart Boom's DGPS connector.
This setup seems to be one of the low cost routes to boom control and autosteer using a 750.
tedbear, thanks to you and everyone for comments and help. | |
|
Raven to Trimble 750
