|
| I believe the fitting you are looking for is part # A15532. If I am reading your post correctly. This would be the large plug you take out almost immediately below the rockshaft housing and goes into the rear end transmission / differential case. The seal washer part # is H851R. It should have a 1/2 male pipe that sticks out at you when installed. The threads that go into the case are 1.125" and are of the UNF type which is Unified Inch Fine Screw Threads. Correct me if I am wrong. Hope this helps.
Edited by Time Maker 1/5/2015 23:02
| |
|
4640 transmission plug thread size
