|
Central ND | Point problems is probably what you have. They are very simple. They are just a on-off switch for electricity flow. Get a point file or an abrasive and file the contact points. Remove corrosion and burn spots . On high cam on the distributer cam there should be a gap, in the points of probably .023" gap. or so. (I'm just guessing at the gap size though)On low cam, they need to have a positive contact.
You may need new points if the old ones are in burned up condition.
Edited to fix the point gap error to realistic measurements....
Edited by School Of Hard Knock 12/27/2014 19:19
| |
|
Ford 4000 gas won't fire
