|
WC Saskatchewan | Check out bulltear cnc, www.bulltear.com
I did a lot of research when I bought my 4x8 table, and I have no regrets going with bulltear.
I beleive you would get as good or better table for less money.
they use candcnc electronics, which is kinda the standard for hobby tables, and used quite a bit for commercial shops also.
the bulltear has a very good rail system for the gantry. And is very fast and has good acceleration. (Important)
Im not trying to talk you out of a plasmacam, Just do your research, and read up in some of the forums. I like plasmaspider.com pirate4x4.com cnczone.com candcnc.com etc.
I have about $12000 into mine, including the water table, machine torch, and hypertherm pm45.
Water table is important in a shop. They make ALOT of smoke without. A downdraft system works, but I wouldnt want it sucking all the heat out of my shop.
Only your imagination limits you once you have a table.
good luck!
Edited by F_armer 10/26/2014 01:06
 (20140409_152618.jpg)
 (2014-05-20 22.40.10.jpg)
Attachments
----------------
 20140409_152618.jpg (87KB - 177 downloads)
2014-05-20 22.40.10.jpg (63KB - 192 downloads)
| |
|
PlasmaCAM
