|
Leesburg, Ohio | Ron: We had major leaks with the steel connections also. Used the pipe dope that they sent from Rapid Air. Had to take every one apart and apply Teflon thread tape. No more leaks there.
Have you had any leaks in the o-ring fittings at the Rapid-Air junction blocks? We seem to have a different one every week or two where the o-ring blows out of place. I may have tightened the big plastic retaining nut too tight when I installed them. Usually we can back off the plastic nut, slide the retaining rings and o-ring apart, put it back together, and not tighten it so much, and it works. But some have to be replaced to get them to hold.
Just curious if anyone else is having this issue? | |
|
Rapid air VS Fast Pipe
