|
North west MN | http://www.ravenprecision.com/us/Manuals/manualListing.jsp?ID=5&Typ...
VOLUME/MINUTE RATE FAULT
Depress until DATA display flashes. A low limit flow rate may now be entered.
If the actual volume per minute falls below this limit, the Control Valve stops
closing, an alarm sounds, and the display flashes "-LL-". The low limit value
should be determined with all booms ON. This value is automatically proportional
to the percentage of booms that are ON. (i.e. If the entered low limit is 4 and
half the total boom length is shut off, the Console automatically reduces the low
limit to 2). | |
|