|
Butterfield, MN | I was going to recommend going to Envizio Pro and SwitchPro until I read that you already have the Accu-Boom node. Since the 4400 is doing your product control (it basically has a product control node and boom/speed node built into it), it's going to be a little more involved to totally replace it. Your least expensive option would be to just get the Envizio Pro and hook it into the CAN system in place of the Cruizer II. You'll want to make sure that your 4400 is updated to at least version 1.9. 2.0 is the current version out for this, so might as well get it updated to that if you're going to do it anyway. At this point, the 4400 will be doing your rate control, and you'll continue to use the switches on it to turn sections on and off, but all your rate information, section painting, Rate and Accu-Boom setup will be done through the Envizio Pro.
If you're truly trying to get down to one controller in the cab, the Envizio Pro and SwitchPro will plug right in place of the 4400, you can remove the Cruizer and the existing Accu-Boom system, and make it work pretty simply that way too. At least you have a couple options to think about. | |
|
Need help deciding...switching from Raven Cruizer II & 4400 to??
