|
| As the above post mentioned - check the red button is pulled out. Also check the wires inserted into it were stripped first - had a couple like that.
You will have one black L shaped terminator in the first harness connected directly to port A. The other terminator goes onto the main harness right near where it connects to the first harness. There should be a grey cap on the spare plug down near the IMD600.
Another common issue just recently, is that the grey outer connector shell on the IMD600 may have been installed the wrong way around, causing connection with the wrong pins on the IMD600. You will have to compare this to a known working IMD to check this for sure. I don't have a picture of this handy right now. Someone else may have one handy. | |
|
New Install CFX 750 with EZ Pilot Problem
