|
North East Kansas | Here are some of the pictures I took. Please keep in mind that I haven't even thought about tidying wires up yet. I merely attached some to see how long they are and if they will reach certain locations. In the second picture, I was wanting to put the pushbutton from a 275 guidance into the hole by the #5. I would have to bore it out an 1/8" to make it fit. I didn't mount the module in the picture, but that is where the instructions say to mount it. It might be hard to get the module mounted exactly parallel with the centerline of the tractor. Is it paramount to get it perfect? I also took a picture of the bottom, back, right cornerpost where I might try to feed my antenna cable through. Let me know your thoughts.
Edited by steve1616 4/3/2014 21:34
 (015a49937fd1784b8bc68f367d1b18799b4f499535.jpg)
 (0110a642e0737f004bde7b2c26896fd1152e32ca5d.jpg)
 (016278fc2cc882bc390c361b9b6369eea79f83f5c2.jpg)
 (01f9e7b3776b2f8553c341e31627be693530802a48.jpg)
Attachments
----------------
 015a49937fd1784b8bc68f367d1b18799b4f499535.jpg (25KB - 39 downloads)
0110a642e0737f004bde7b2c26896fd1152e32ca5d.jpg (47KB - 47 downloads)
016278fc2cc882bc390c361b9b6369eea79f83f5c2.jpg (35KB - 46 downloads)
01f9e7b3776b2f8553c341e31627be693530802a48.jpg (47KB - 36 downloads)
| |
|
Ez-pilot installation on MX220 tips
