My planter does not have clutches. I will just be using 3 hydraulic motors to turn off sections as needed. I am still fighting this hook up. I finally got power to the master switch but the Fmx will not recognize the modules. Everything is plugged in as far as I can tell. I don't know about power to the modules however. If I understand correctly they have a separate power supply for them. Is there a plug that I need to get power to someplace? There was a plug in the cab that has a black and red wire going into it that is empty. This is in the harness that goes back to the planter. Is this where I need to put power to? |