|
roaming | So your liquid fertilizer is controlled by some other method (ground drive, external rate controller, etc), NOT the Pro 600, right?
In this case, you need to create/assign a Manual Control Channel to represent your liquid.
Toolbox > Manual, then rename ManApp1 to "Liquid" or "Starter" or something similar. Set the Form to Liquid, and then set Link to Layout = Seed.
Then go to Work Condition > Layer, Layer 2, and select your new Manual Control Channel, and then assign your starter product.
To control the mapped rate, you'll need to put ManApp1 on a Run screen (Toolbox > Layout). | |
|