mvisto - 2/24/2014 09:51
Am I correct in reading that the Pro700 Task Controller currently balks at multiple control nodes?
Yes. For now there is a single node/implement limitation.
mvisto - 2/24/2014 09:51
If the Task Controller will not work with multiple nodes, will the VT be able to utilize multiple control nodes? (For example: 2 Precision Air Cart control nodes; or the Precision Air Cart control node along with a Dickey John ISO Strip Till control node)
Yes. You can use up to 16 nodes/implements with the Pro 700 VT.
mvisto - 2/24/2014 09:51
If the Pro700 can run multiple VT control nodes but not multiple Task Controller control nodes, is the Task Controller then available to monitor and VR control 1 of the nodes. Can one of the nodes be designated for monitoring and VR control?
Yes. You can select 1 (and only 1) of the connected implements to use with the Pro 700 Task Controller, and you'll still retain control of all implements via the VT.
mvisto - 2/24/2014 09:51
Does the Precision Air Cart control node utilize a PWM signal to control the VR electric motor? Can this signal be utilized to control a PWM hydraulic flow valve? If not, then the only other option I have found is one of the Dickey John ISO control nodes.
Good question, and I don't know the answer. | 
Pro700 ISO VT & Task Controller
