|
Woodham, Ontario | When I demoed a fendt 822 I plugged my SeedstarXP planter into it and it showed up and the layout was similar. But it was VERY ugly and much harder to make out the buttons. Might not be worth it.
It is possible to connect a Deere display to the 9-pin ISO plug inside the cab and connect the drill to the ISOBUS connector at the back of the tractor. You will need to disable the VT on the vario terminal.
My pottinger mower did not show up on the demo tractor either...
I'm going to try to run a new NH square baler on the ISOBUS on a 7230R or 2630 on the 7930. Hope that works! | |
|